FUEL BED LAYOUT - ccontinued
5. Finally, take the four remaining pebbles and place
at the back of the fuel matrix as shown.
Once again, the pebbles may be orientated as desired
in order to give a realistic effect. Avoid pushing the
pebbles down between the supports. The fuel bed is
now complete.
The fire is designed to operate correctly with the pebbles supplied when assembled according to the instructions.
Never add to the sixteen pebbles, or change them for a different type. Never throw rubbish or other matter onto
the coal bed.
Due to the light colour of the pebbles, some discolouration/sooting is to be expected during normal use.
FITTING THE DECORATIVE FRAME AND FRONT
The appliance is supplied with a decorative frame in a variety of finishes. The frame is held onto the firebox by
one of two methods; either by magnetic pieces fitted to the steel backing plates, or as a three piece clip-on assem-
bly.
If not pre-fitted, the clip-on frame pieces should be hooked over the outer edges of the fireframe, and pushed
firmly home. The sides should be fixed first, followed by the top bar, which overlaps the sides. Push firmly home.
A plastic protective film may be applied to the outside of the frame
and should be removed at this stage.
IMPORTAANT :: DDue tto tthe ppossssibility oof ssharp eedggess, ccare sshould bbe
taken wwhen hhandlingg tthe tthree-ppiecce fframe ccomponentss. TThe uusse oof
protecctive gglovess iiss rreccommended.
Place the decorative firefront in front of the fire and slide the ashpan
door into place. The firefront shown in these instructions may be dif-
ferent to the one supplied with the appliance.
TESTING AND COMMISSIONING
Turn on and test the gas supply up to the fire for any leaks, in accordance with current edition of BS6891.
When the appliance is first used, protective oils coating the firebox may burn off. It is advisable to ventilate the
room during this period for at least one hour.
OPERATING TTHE FFIRE
The pilot is visible through the left hand side of the front coal strip. Push in and
turn the control knob to the SPARK position, and hold there for a few seconds.
Continue turning anti-clockwise through the spark click to the PILOT light posi-
tion, ensuring the pilot has lit. If not, return the knob clockwise, and repeat.
When the pilot lights after the spark, keep the knob depressed for approximately
ten seconds. Now release the knob and the pilot should stay alight. If not, retry
ignition. If the pilot is extinguished during use, wait three minutes before repeat-
ing the ignition procedure.
To achieve the HIGH setting, push the control knob in slightly and continue turning anti-clockwise to the high
(large flame) position. The main burner should light after a few seconds.
11
13.0
12.1
14.0
14.1
(28 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais